| International standards |
ISO 289:2005, ASTM D 1646, DIN 53523, BS 903: Part 58,
AFNOR T43-00/005, BS 1673, GOST 10722-76, JIS K6300,
TGL 25-689 |
| Die configuration / rotor |
According to international standards large (ø 38.1mm) and small (ø 30.48mm) rotor |
| Force measurement |
In–line torque transducer |
| Closing force |
11.5 kN |
| Rotor speed |
0 to 50 turns per minute, 0.01 steps (0 to 5.25 radians / second) |
| Relaxation |
According to ISO 289:2005, DIN 53523 Part 4 |
| Torque range |
0.01 to 230 MU |
| Sample volume |
Two specimens having a combined volume of 25 cm3 |
| Temperature control system |
Ambient to 232°C, percision +/- °C, digital, microprocessor controlled |
| Temperature check system |
Recordings of the temperature gradient on the screen, PID microprocessor monitored |
| Calibration |
Fully automatic by built-in calibration weights, software guided |
| Measured data |
Mooney- value (MU)
Temperature (°C, °F)
Time(min-min/min-sec)
|
| Data Interface |
Ethernet (10/100MBit), USB (int.), CF card (int.), RS232 (opt.) |
| Data points |
Over 3500 data points available
Including: Initial viscosity, ML/ML 1+X, Y+X+Z, Stress relaxation (log-log), Slope, Intercept, Regressions coefficient, Scorch viscosities and cure times
|
| Pneumatics |
min. 4.5 Bar / 60 psi |
| Electrical |
220 V- 230 , 6 Amps |
| Instrument options |
- Instrument control panel with 5" touchscreen display and printer
- Easy access and encapsulated electronic system
- Double channel forced air cooling system
- Low-temperature cooling system MCool 10
- M-VS 3000 constant volume sample cutter
|