| Principle |
Non dispersive infrared sensor (single beam system)
O2 sensor: built-in magnetic or galvanic sensor, or external zirconia sensor (ZFK7) |
| Measurable components and ranges |
NO: 0–10 ppm…100 ppm
SO2: 0–10 ppm…100 ppm
CO2: 0–5 ppm…50 ppm
CO: 0–5 ppm…50 ppm
Built-in galvanic O2 sensor: 0–10 vol%…25 vol%
Built-in magnetic O2 sensor: 0–5 vol%…100 vol%
External zirconia O2 sensor: 0–5 vol%…25 vol% |
| No. of ranges |
Up to 2 ranges per component |
| Repeatability |
≤ ±0.5% FS |
| Linearity |
≤ ±1% FS |
| Zero drift |
≤ ±0.5% FS per week |
| Span drift |
≤ ±2% FS per week |
| Response time (for 90%) |
≤ 30 s (Loss time may vary with gas switching timings) |
| Analog output signal |
4–20 mA DC or 0–1 V DC |
| Display |
Backlit LCD (Japanese, English, or Chinese available)
Instantaneous value, O2-corrected instantaneous value, O2 corrected average value, O2 average |
| Range switchover |
by key operation, automatic, or by external contact input (option) |
| Contact input (option) |
Voltage contact input (12–24 V DC, up to 15 mA)
Remote range-switching, auto-calibration remote start, remote hold, average reset |
| Contact output (option) |
SPDT relay contact (24 V DC/1 A)
Device error, calibration error, range identification, auto-calibration status, solenoid valve drive for auto-calibration, limit alarm, CO peak alarm |
| Atmospheric pressure correction (optional) |
Built-in option available |
| Standard functions |
Output hold, auto/manual range switching |
| Option |
Auto calibration, auto calibration remote start, remote hold of output, range identification contact output, high/low limit alarm, O2 correction, O2-corrected average values, average resetting contact input, CO peak alarm contact output |
| Communication (option) |
RS-485 (Modbus) (9-pin D-sub output): half-duplex, start-stop synchronization system |
| Flowmeter |
Provided |
| Gas inlet/outlet |
Rc 1/4 or NPT 1/4 internal thread |
| Purge gas flow rate |
1 L/min (as needed) |
| Reference gas |
Required (dry N2 or dry air) |
| Surrounding temperature/humidity |
-5°C to +45°C, RH90% or lower (non condensing) |
| Power supply voltage |
100–240 V AC, 50/60 Hz |
| Power consumption |
Approx. 100 VA |
| Dimensions |
133 (H) × 483 (W) × 382 (D) mm |
| Weight |
Approx. 11 kg |
| Conformity |
CE Marking |