- Fault location with connected loads
- Reduced downtime in the network
- Portable equipment with short-term payback
- Reliable identification of the gases produced by burning cables
- Cable faults in the electricity network can often be difficult to locate. With our Cable HUNTER you can locate cable faults in the low-voltage network independently and immediately after the fault is reported, without any help from external cable measurement companies. The Cable HUNTER operates using two sensors that react to the gases emitted by burnt cable insulation material. When used in combination with the Vacuum Probe System 15 (VSS 15), it allows you to locate the fault quickly and easily.
Thông số kỹ thuật
- Display :
+ LCD graphic display with 128 x 64 pixels, illuminable
+ Display of measured value and bar graph
- Power supply : NiMH battery pack, 4.8 V, 3.8 Ah
- Operating temperature : -10 °C to +50 °C
- Operating time (without illumination) :
+ > 10 hours including Bluetooth transmission
+ > 11 hours with no Bluetooth transmission
- Charging :
+ Charging cradle, via 12 V or 230 V supply
+ Charging time is approximately 3 to 5 hours
- Data storage : Flash memory with 4 MB for more than 100,000 measured values
- Protection category : IP 54
- Dimensions : 168 x 90 x 80 mm without connection couplings
- Weight : Approx. 1,100 g, including battery
- Operating principle : Specialised semiconductor sensors
- Response time : T90 ≤ 10 seconds
- Pump capacity : > 40 l/h, >300 mbar