Features
The Antenna Surge generates the waveform required by IEC 60065, 60950 and 62368-1 to test antenna ports at 10kV output voltage.
The MegaPulse is configured with our IER relay and is built in a 19" by 6U enclosure.
Theoretical graphs and actual graphs showing the output of your tester are included with each MegaPulse, allowing easy sanity checks and proof to visiting agency engineers of test setups.
1000:1 BNC Oscilloscope output option allows quick connections and easy evaluation of output waveforms. (Reference only).
Requirements are for positive polarity tests only. No reverse polarity waveforms are available from the MegaPulse Antenna Surge.
Front panel voltage meter shows residual voltage in charging circuit for safer operation.
| Output Peak Open Circuit |
10kV ±3% |
| Main Internal Capacitor |
1nF |
| Internal Virtual Resistor |
1000 |
| Internal HV Power Supply |
|
| Output Impedance |
15 M |
| Trigger Relay |
Complies with IEC 65 |
| Voltage Control |
Manually, by turning a knob in front panel |
| Polarity Control |
Positive only |
| Voltage Display |
5 digit LED display |
| Voltage Meter Resolution |
5V |
| Duty Cycle |
A pulse every 5 seconds, (standard 50 discharges at maximum rate of 12 per minute) |
| Line Voltage |
120V AC, 60/50Hz *optional different line voltage |
| Environmental |
| Operating Temperature |
15-40 ºC |
| Relative Humidity Range |
0-90% non-condensing |
| General |
| Dimensions |
17” wide x 6” high x 17” in deep |
| Weight |
35 lbs approx |
| Options |
| BNCV |
1000:1 BNC Output, compensated for 1MΩ |
| 4M |
4 M resistor load |
| XI |
External interlock; two position terminal block on rear panel must be shorted for high voltage operation. |
| TMM |
Testminder USB computer interface software. The tester can be controlled with a computer. It can also be set to automatically follow test sequences and keep a record with test information. Compatible with Windows 32bit platform. |
| 220, 230 or 240 |
If a different line voltage is desired, with this option we install a step down transformer to be compatible with your line voltage. 220 for 220V, 230 for 230V and 240 for 240V. |